How to Streamline PCB Thermal Design


Reading time ( words)

Thermal issues with a PCB design are mostly determined during the component selection and layout phases. After this point, only remedial actions are possible if components are found to run too hot. Addressing thermal issues early in PCB design, starting at the system or enclosure level to understand the flow environment critical for air-cooled electronics, can streamline the process. Assumptions about the airflow uniformity in early design that subsequently prove unachievable can have a disastrous effect on the commercial viability of the product and meeting the market window.

Begin Before Placement and Layout

Substantial work can be done well before layout is completed within the electrical design flow. A simple representation of the enclosure can provide information about the air flow profile over the board. Start by smearing the total board power over the total board surface, which will provide a temperature map that will show any hot regions that are caused by a badly distributed air flow. Treat the board as a block with an isotropic conductivity of between 5 W/mK and 10 W/mK to optimize enclosure-level air flow ahead of the PCB design.

Components inject heat locally into the board so the heat flux density into the board below a component will be higher than the average for the board. As a result, the local board temperature will be higher than that predicted in the simulation. Refine the model before using the board temperature to estimate component temperatures. If the board temperature at any point is close to the maximum component case temperature, this limit will be exceeded once the component heat sources are represented discretely.

Guesstimate Component Power

At this stage, make a best-guess estimate of the individual power budgets for the main heat dissipating components that will be used in the design and the approximate size of those packages. This will enable describing them as footprint heat sources in the simulation, smearing the remainder of heat uniformly over the board surface.

Before Selecting the Package, Use 3D Component Models

Include some form of 3D component model in the simulation before the component selection is finalized. By feeding the thermal results back before this milestone is reached, the thermal performance will more likely be considered in the package selection criteria. Some ICs are available in more than one package style, and not all package styles perform equally well from a thermal point of view. The need for a heatsink later may be eliminated by appropriate package selection.

Component temperature, either in the form of a case temperature or junction temperature depending on how the manufacturer has specified the component, is the key measure used to indicate whether the design is thermally acceptable.

Read The Full Article Here

Editor's Note: This article originally appeared in the March issue of SMT Magazine.

Share

Print


Suggested Items

Matt Stevenson on Sunstone Circuits' Current Operations

03/25/2020 | Nolan Johnson, I-Connect007
Nolan Johnson speaks with Matt Stevenson, VP of marketing at Sunstone Circuits, who shares an update on the company's current level of business operations under COVID-19 restrictions. Stevenson confirms that Sunstone Circuits is fully operational and classified as an essential business.

Semiconductors in Charge: The Changing Face of PCB Manufacturing

03/11/2020 | I-Connect007 Editorial Team
The I-Connect007 editorial team recently spoke with Chuck Bauer and Dana Korf in a technical discussion that spanned a number of topics around shrinking components, such as redistribution layers (RDLs), active embeddeds, and why even the most revolutionary technologies must show ROI to be successful.

Stencils: Not As Simple As They Seem

02/26/2020 | I-Connect007 Editorial Team
Stephanie Hardin of Integrated Ideas and Technologies Inc. discusses her role in the supply chain as a stencil manufacturer, improvements she sees from micromachined step stencils, and why she believes trying to have standardized stencil layouts is wishful thinking due to the many fluctuating variables.



Copyright © 2020 I-Connect007. All rights reserved.