Everything You Wanted to Know, But Were Afraid to Ask


Reading time ( words)

This month, Testing Todd presents readers’ questions about the basics of electrical test, including the different types of testing available today.

 

Reader: I recently found out that all points are not necessarily checked during electrical test. Why is that and which types of boards do not get all of their points tested? Isn’t there a chance that something will be missed? Is there a type of test that hits all of the points?

Todd: When a board is programmed for test, certain points of the board are de-selected. To properly answer this question, we need to revisit IPC-9252A, Amendment 1, which stipulates that Class I and II can remove the mid-points of a net on the board. What this means is that we are only concerned with the end-to-end connectivity of the net. With IPC Class III we need to include the mid-points of the net to quickly isolate any problems in the chain. However, this is cautioned by the additive properties of solder mask encroachment or via-fill. In these cases, although Class III, they cannot be tested and are allowed the waiver under the 9252A with Amendment 1 release.

Within the Class III requirement of 9252A with Amendment 1, we can add probes to validate each landing pad. With Class I and II we are only validating the end points of the net to make sure the signature is intact. By adding mid-points with Class III we validate that the connectivity is valid to all landing pads. This is in case there may be contamination to any of the intermediate landing pads in the chain of the net.

Adding all pads in the net is referred to as Class III per IPC-9252A with Amendment 1, which hits all of the points.

Read the full column here.


Editor's Note: This column originally appeared in the May 2014 issue of The PCB Magazine.

Share


Suggested Items

The Institute of Circuit Technology Annual Symposium 2018

06/18/2018 | Pete Starkey, I-Connect007
ICT technical director Bill Wilkie is well-known for choosing notable venues for Institute of Circuit Technology events, and his choice for this year’s Annual Symposium was the National Motor Museum, located in the village of Beaulieu in the heart of the New Forest, a national park in the county of Hampshire in Southern England. The region is known for its heathland, forest trails and native ponies.

Experts Discussion with John Talbot, Tramonto Circuits

06/06/2018 | I-Connect007 Editorial Team
For this first issue of Flex007 Magazine, we interviewed John Talbot, president and owner of Tramonto Circuits. Headquartered in metro Minneapolis, Minnesota, Tramonto manufactures flexible and rigid PCBs for a variety of industry segments. Editors Andy Shaughnessy, Patty Goldman and Stephen Las Marias asked John to discuss the challenges and opportunities in the world of flexible circuits, and some of the trends he’s seeing in this market.

Elga Europe Reality and Ultra-High-Resolution Photoresist

04/24/2018 | Patty Goldman, I-Connect007
While walking around the PCB hall at productronica, I was approached by my good friend Gene Weiner. Gene emphatically directed me to the Elga booth to find out about their new extra-thick dry film that can image extremely fine features with a perfectly perpendicular sidewall. Elga Europe CEO Giorgio Favini filled me in on the details.



Copyright © 2018 I-Connect007. All rights reserved.