Joe Clark Discusses DownStream’s Updated Tool Lineup and IPC-2581


Reading time ( words)

DownStream Technologies recently revamped their entire product line, from CAM350 through BluePrint-PCB. DownStream co-founder Joseph Clark and Guest Editor Kelly Dack discuss some of these updates, including a new GUI and capabilities such as 3D analysis, as well as news about IPC-2581.

To watch this interview, click here.

Share

Print


Suggested Items

XNC Format: Gerber Takes Data Into the Future

05/20/2019 | Denis Morin, Karel Tavernier, Jean-Pierre Charras, and Marius Matioc
The problem is that so many NC files are of deplorable quality because the NC format was never designed as a data transfer format. It has always been a machine driver and contains all sorts of information that a drilling machine needs, but that is irrelevant and confusing for data exchange.

Learning to Be More Flexible: Case Studies on Improving FPC Design

05/14/2019 | Todd MacFadden, Bose Corporation
As miniaturization requirements force manufacturers to pack more functionality into ever-smaller packages, it becomes more difficult to conform to IPC construction recommendations. Achieving robust FPCs requires frequent, iterative interaction internally among the mechanical, electrical, and PCB design teams, as well as with the fabricators and assemblers. The sooner in the design cycle you can engage the supplier and assembler, the better.

Technically Appropriate Material Choices are Key to Design Success

05/16/2019 | Nolan Johnson, I-Connect007
Materials are no longer a passive part of the design; they play an active role in the manufacturability, reliability, and speed of a PCB. I-Connect007’s Nolan Johnson and Mike Creeden, founder of San Diego PCB Design, discuss several key characteristics that designers should consider in their material selection process.



Copyright © 2019 I-Connect007. All rights reserved.