Irridian Invests in New Printed Circuit Board Design Software Suites


Reading time ( words)

Recently acquired by Hindley Circuits, Irridian Industrial Electronics, has invested in introducing state-of-the-art PCB design software to significantly enhance the accuracy and speed of its design services.

The new Cadstar and Altium design software platforms have modern and interactive user interfaces. The cutting-edge design software platforms will allow us to design complex multilayered printed circuit boards while also incorporating high speed design requirements.

Both the Cadstar and Altium platforms allow all aspects of the PCB design cycle to be addressed – right from schematic capture and PCB layout through to documentation and simulation – meaning that our PCB designers can be seamlessly connected to all elements of the design process. We have already seen the benefits of this thanks to a rapid increase of speed and accuracy across the whole process.

We have been greatly impressed by our existing customers interest in Irridians design services and look forward to sharing with them the benefits that the new software will bring to our service offering. We are currently looking to hire an additional experienced PCB Designer in the very near future

Share

Print


Suggested Items

EMA: Cadence Moves Simulation Further Up in the Design Cycle

03/15/2019 | Andy Shaughnessy, Design007 Magazine
Cadence Design Systems recently integrated more of its Sigrity capabilities into the front end of its PCB design tools. During DesignCon, Chris Banton of EMA Design Automation spoke with me about how this drive for “model-less analysis” benefits the PCB designer who can now access signal and power integrity, DFM, and electrical rule checking functionality early in the design process and have fewer issues later.

Words of Advice: What are Your Biggest Design Challenges?

03/11/2019 | Andy Shaughnessy, Design007 Magazine
In a recent survey, we asked the following question: What are your biggest design challenges? Here are just a few of the answers, edited slightly for clarity.

Todd Westerhoff Discusses His New Position and Much More

03/07/2019 | Andy Shaughnessy, Design007 Magazine
At DesignCon, I met with our old friend Todd Westerhoff, a veteran signal integrity engineer. Todd joined Mentor, a Siemens Business, since we last spoke. We discussed his new job responsibilities, his drive to get more designers and engineers to use SI tools, and the increasing value of cost-reduced design techniques versus overdesigning PCBs.



Copyright © 2019 I-Connect007. All rights reserved.